-
Rubber Gasket Seals in Electronic Assemblies
Dec 10 ,2015
A Rubber Gasket Seal is often an integral part of an electronic assembly. Seals, whether silicone or rubber, are required to protect the end product from environmental conditions that it is exposed to during use. A rubber or silicone seal can be designed to achieve what is called an International Protection Rating. This rating is an industry standard to classify the degree of protection against so...
View More
-
Air Filters And Air Intakes
Jan 08 ,2016
Like humans, almost all mannerism of contraptions that have a motor require air to function. Vacuum cleaners to hair dryers to lawn mowers and yes; cars, all require the intake of air to work properly. In cars, air is required in the combustion chamber where fuel is burned to produce power. If you didn't pay attention in basic science class, air is needed to keep a fire burning. Same concept here....
View More
-
What Is The Biggest Problem Of Diesel Smoke
Feb 15 ,2016
In America two centuries later, it's time to come to grips with the liability faced by fire departments that fail to take heroic measures to protect employee health. Numerous human studies demonstrate diesel exhaust exposure increases cancer risk. In fact, long term exposure to diesel exhaust particles poses the highest cancer risk of any toxic air contaminant evaluated by the California Office of...
View More
-
Advantage and Application of EPDM Rubber
May 07 ,2018
EPDM belongs to one kind of ethylene-propylene rubber, which make it good performance in ozone resistance, and high-temperature resistance. EPDM rubber products are widely used in auto industry, and electronics industry. Comparing to other ordinary rubber and special polymer rubber, EPDM rubber has below advantages: 1. Higher cost performance The density of raw rubber is only 0.85-0.9...
View More
-
The Three Points To Judge The Un-Curing Silicone Rubber Products
Oct 12 ,2018
When producing Silicone Rubber Parts, some time will suffer the appearance or function that fail to meet the production standard after vulcanization. This is because the material did not have full vulcanization. How to judge this kind of situation? According to what appearance 1.Entire part un-cure Judging method: After vulcanizing, the silicone products entirely become soften and sticky. Using fi...
View More